Gentiv ultra degrees should start to bend
Gentiv ultra degrees
should start to bend [Applause] I do have some tension in this [Applause] this
heat gun says it's 1,100 degrees right now [Applause] it's getting it hard
that's the truth [Applause] [Music] [Applause] is starting to then [Applause]
[Music] [Applause] all right now we have to do is get it to stay in that shape
right about right about there there it's bent what we're going to do and get it
wet that'll cool this lexan off well let's be invent there we go it should
retain its shape now oh I'll Drive that out we'll drive that out and save it
for later yep yeah we did where's my I think I bent it a little bit and I've
got too much of an angle on it but I think that'll work very good next thing
we're do is we get our mount our air cylinders onto this and then we'll be
almost done with this unit all right th Gentiv ultra
Reviews e other thing we need to do is we need
to drill and tap the bottom of the cylinder this is how we're going to mount it
to that plastic base plate so we've got a center drill enough in there [Music]
[Music] and there we've got a hole drilled and tapped in the end of this
cylinder for our mounting to the base plate to another cylinder and we'll go
mount it to the base plate all right and we have assembled it well I went ahead
and assembled it that all it is is a little flathead screws go through the
chamfer the on the base plate screws right into the cylinder like that oh I did
that on purpose screws right into there that holds that to there I've hooked it
up to my pressure gun and that's how it works and it is air pressure we can see
here so it's air tension so and this can go so as opposed to your spring
tension you can keep going up on this well until it hits 110 psi which would
surely pull pull your member completely off and you would be able to see the
other end of it
https://www.facebook.com/Gentiv-Ultra-479890469467727/
https://www.facebook.com/Gentiv-Ultra-479890469467727/
Comments
Post a Comment